Docker - installing a package

Discussion room for Docker, a lightweight virtualization application that gives you the ability to run thousands of containers created by developers from all over the world on DSM
Forum rules
We've moved! Head over to Synology Community (community.synology.com) to meet up with our team and other Synology enthusiasts!
checky
I'm New!
I'm New!
Posts: 7
Joined: Wed Mar 26, 2014 12:22 pm

Docker - installing a package

Unread post by checky » Fri Jul 13, 2018 9:01 am

Hi there,

I'm questioning how to run a package on docker.
I want to install 'Loxberry', it's installing fine, but after that, I don't know what to do to access the webpage of it to configure.

Probably it's a step that is common to docker to enable the ports etc.. but I'm not figuring out how it works.

Thanks!

KR,
Checky

User avatar
Rusty1281
Sagacious
Sagacious
Posts: 3246
Joined: Fri Jun 03, 2011 10:51 pm

Re: Docker - installing a package

Unread post by Rusty1281 » Fri Jul 13, 2018 12:40 pm

What image did you use to begin with? Does it come with instructions on how to set up that docker container?
Synology DS918+ (4x4TB WD RED - RAID 5 with 2x250GB 960EVO NVMe) | Synology DS412+ (4x3TB WD RED - RAID 5) | RT1900AC

checky
I'm New!
I'm New!
Posts: 7
Joined: Wed Mar 26, 2014 12:22 pm

Re: Docker - installing a package

Unread post by checky » Fri Jul 13, 2018 12:43 pm

Dear,

it's this that I've downloaded and enabled.
https://hub.docker.com/r/gagi/x86-loxberry/

No description howto.

User avatar
Rusty1281
Sagacious
Sagacious
Posts: 3246
Joined: Fri Jun 03, 2011 10:51 pm

Re: Docker - installing a package

Unread post by Rusty1281 » Fri Jul 13, 2018 1:07 pm

Maybe you will have better luck on lox forum then here... haven't tried it. Also someone will post for sure if they have any info on the matter.
Synology DS918+ (4x4TB WD RED - RAID 5 with 2x250GB 960EVO NVMe) | Synology DS412+ (4x3TB WD RED - RAID 5) | RT1900AC

zardoz
Experienced
Experienced
Posts: 141
Joined: Sat Oct 19, 2013 11:08 pm

Re: Docker - installing a package

Unread post by zardoz » Sat Jul 14, 2018 8:19 am

Wow you are a very trusting soul.

There are no details with that package, no reference git repo.
That image could do anything to your network and do anything with what you use loxberry for.

Without the detail it is very difficult to tell what ports it exposes (and therefore need mapped) and what volumes need to be mounted as well.

I would recommend building you own docker image instead of using this one.

Locked

Return to “Docker”