Synology Inc. Online Community Forum

by **Franklin** » Mon Oct 30, 2006 10:47 pm

Official list of UPS systems tested by Synology
User Reported Compatible Uninterruptible Power Supplies

If you wish to post your UPS, please reply with the make/model of your UPS and the Synology Server you are using. Thanks!

by **izani** » Mon Dec 11, 2006 2:28 pm

My UPS - APC Back-UPS CS 650 via USB connection.
Using 106e latest firmware, not beta one.

Cheers

by **frakass** » Thu Dec 28, 2006 1:15 am

Using APC Back-UPS CS 500 via USB,
with a Synology CS-406 running latest beta firmware.

by **Jaguar** » Tue Jan 09, 2007 1:36 pm

APC Back-UPS RS 800 works fine with my CS-406 with v2.0.4-.3.0382 firmware.

by **KWCIndy** » Thu Jan 11, 2007 1:22 pm

I can report success with recognition of the APC BACKUPS ES-650 using the data USB connection to the CS. Parameters appear in the CS interface and give me battery level and expected life. BUT I haven't unplugged the UPS to test the shut-down feature yet...

I have noticed that it seems you need to "re-enable" the UPS each time you disconnect/reconnect, but now that I have everything hooked up and stabilized, that shouldn't happen too often. This may be expected behavior, but don't forget about it.

FWIW the ES-650 reports just over 30 minutes of expected life with the CS-406 attached.

I have the CS-406 running Firmware Version: 2.0.4 - 3.0382

by **Student1979DA** » Mon Apr 23, 2007 8:57 pm

Hello,
can anyone send or post a screenshoot of the UPS configuration?

tanks
marco

by **Jaguar** » Mon Apr 23, 2007 9:14 pm

Yes :

by **Student1979DA** » Tue Apr 24, 2007 8:54 am

Thanks...

by **bsa** » Thu Jun 28, 2007 10:27 pm

APC BackupUPS RS1500
CS407 FW0462

by **Toxic** » Thu Jun 28, 2007 10:34 pm

APC Back-UPS ES 700 - CS407 (Firmware .462)

by **phlampe** » Fri Jul 20, 2007 2:37 pm

Hello All !

Has anyone tried APC Back-UPS models (500 or 650 VA) with CS407 and/or DS207 ?

And what about MGE's models (Protection Center and Ellipse ASR) ? Are they also naturally recognized by Synology's system software ?

Thanks for your answers,
Paul-Henri

by **thansen** » Thu Aug 02, 2007 8:10 pm

APC Smart-UPS 750 XL via USB, works fine with a Synology DS-107+.128 firmware 2.0.3-0456.

Regards Thomas

by **HarryPotter** » Mon Aug 27, 2007 6:43 pm

CyberPower OP 1500TE doesnt work (no UPS detected) on DS-106e

by **Loeffel** » Tue Aug 28, 2007 6:24 am

Is the UPS shown at the status page under UPS devices?
If it is shown there, please try this:
1. Reboot your CS407 and see if the problem persists.
2. If the above is of no help, please unplug the UPS from CS407, wait for few minutes for the system to refresh then connect the UPS again.

I had the same problem with my UPS after FW upgrade. An additional reboot made it work normally again.

by **HarryPotter** » Tue Aug 28, 2007 8:37 am

Loeffel, was this an answer to me? I dont have a CS-407 :wink:

No the UPS is not shown in the status page. And even not after reboot or re-plugin.

I dont really care, it was just a statement that this UPS doesnt seem to be compatible.

Synology Inc. Online Community Forum

Compatible UPS (Uninterruptible Power Supply)

Compatible UPS (Uninterruptible Power Supply)

APC Back-UPS RS 800

CS-406 and APC UPS ES-650

Re : screenshoot of the UPS configuration

Who is online