I have a QNAP and a Synology
When I upgraded my latest C200 from popcornhour to the latest firmware, I couldn't connect to the synology anymore.
I could connect to the qnap.
the C200 gave me a "unable to resolve hostname". All settings where correct.
The only fix was to enable guest acount, then I could access the synology mapped share again.
If i disable the guest acount after that, it works, until i reboot the popcorn hour or shut the switch down. Then I have to AGAIN enable go to the share, then disable the guest acount.
Can synology offer a fix for that ?
2x Synology 1511+ (1 Main and 1 Backup)
1x Corsair Value 2GB 200-Pin DDR2 800 SO-DIMM PC6400 - VS2GSDS800D2
10x 2 To Hitachi Deskstar 5K3000 SATA Revision 3.0 (Raid 5 SHR on Main and Backup)
D-Link DGS-1210-16 Gigabit Switch with Dual Gigabit LinkUp (IEEE 802.3ad) (Jumbo Frames Support Turned Off)
All Wired Setup with Cat6 UTP Cables 3 meters each
1 PS3, 2 PopcornHour C200, 2 HDTV PVR Receivers, 4 PCs, 1 Printer, 25MB Internet Connection Box with Built-In Router